Any one remember a 1970 mk 2 with reg no url 202H
I have been offered it and want to see if anyone has any history...
vin is: ba91jb40620
1970 Mk2 - URL 202H - anyone remember it ?
Moderator: LCR Members
-
- Learner Driver
- Posts: 4
- Joined: Mon 21st Apr 2008 12:00 am
- LCR Membership Number: 0
- H Cortina
- Woodrim
- Posts: 1089
- Joined: Fri 8th Dec 2006 1:00 am
- LCR Membership Number: 2088
- Location: Rochester Kent UK
- Contact:
-
- Learner Driver
- Posts: 4
- Joined: Mon 21st Apr 2008 12:00 am
- LCR Membership Number: 0
thanks.
Have gone to see the car and it seems genuine. The UK V5 and engine number check out with what the DVLA records indicate...
I gathered the following checks on bsc, here and lotus site and checked the them on the car...
1) Battery in boot, no sign of cuts, welding on inner wing. There might be a old neg earth sticker on inner wing in boot
2) 3020e sometimes just stamped in a ground off area pass side of block,
L stamped in between drivers side engine mount. engine no: 681F-6015-GA
3) High top rad
4) Black door tops
5) 140mph speedo and 8k rev counter
6) starter solenoid on fire wall (plenum chamber)
7) split prop with tubular mount
anti tramp/radius arm at rear
9) brake calipers on front of rotor
10) strut top strenghteners fitted
11) captive nuts on bracket for servo
12) banjo on clutch salve cylinder (looks knackered !)
Have gone to see the car and it seems genuine. The UK V5 and engine number check out with what the DVLA records indicate...
I gathered the following checks on bsc, here and lotus site and checked the them on the car...
1) Battery in boot, no sign of cuts, welding on inner wing. There might be a old neg earth sticker on inner wing in boot
2) 3020e sometimes just stamped in a ground off area pass side of block,
L stamped in between drivers side engine mount. engine no: 681F-6015-GA
3) High top rad
4) Black door tops
5) 140mph speedo and 8k rev counter
6) starter solenoid on fire wall (plenum chamber)
7) split prop with tubular mount
anti tramp/radius arm at rear
9) brake calipers on front of rotor
10) strut top strenghteners fitted
11) captive nuts on bracket for servo
12) banjo on clutch salve cylinder (looks knackered !)
-
- Learner Driver
- Posts: 4
- Joined: Mon 21st Apr 2008 12:00 am
- LCR Membership Number: 0
-
- Learner Driver
- Posts: 74
- Joined: Tue 5th Dec 2006 1:00 am
- LCR Membership Number: 2044
-
- Learner Driver
- Posts: 4
- Joined: Mon 21st Apr 2008 12:00 am
- LCR Membership Number: 0
its definately worth saving...but my pockets aren't that deep (or maybe my arms are too short !)
Seller wanted 6900 euro (about 5500stg)
it probably needs a engine rebuild, jacking points front and rear, chassis cross member around front seats, bottoms of door bubbling, scuttle panel on driver side is bubbling and out of alignment with wing...
the car is about 30 miles outside Dublin ....
Seller wanted 6900 euro (about 5500stg)
it probably needs a engine rebuild, jacking points front and rear, chassis cross member around front seats, bottoms of door bubbling, scuttle panel on driver side is bubbling and out of alignment with wing...
the car is about 30 miles outside Dublin ....
-
- Minilite monster
- Posts: 989
- Joined: Tue 5th Dec 2006 1:00 am
- LCR Membership Number: 1981
- Location: n.london
- Contact: